Burner Control Brahma DSM 11P – The use of a specific construction technique and the adoption of surface-mount technology for electronic components have made it possible to create a structure with a compact size. The plastic casing protects the device against possible damage caused by impacts, tampering, dust accumulation, and contact with the external environment. A varistor protects the device from voltage spikes that may occur in the power distribution network. Finally, a resistor in series with the block signal output can be installed to protect the equipment from possible wiring reversals of the remote release contact.
The table in Figure A shows an example of types of UV sensors divided according to the orientation of the flame with respect to the container. The following figure illustrates the types of connection for FD.. flame sensors, suitable for both gas and oil applications, with dimensions related to the templates for their mounting. To fix these flame sensors, it is recommended to use Ø 4mm screws. In the case of flame control with the FD sensor, only intermittent operation is allowed (a regulation stop every 24 hours is necessary to allow the device to check the efficiency of the FD.. sensor).
FEATURES
- Type CE certification (CE PIN 0051CM4045) in accordance with the European Gas Directive 2009/142/EC;
- Compliance with EN298:2003 (European standard for automatic gas burner control systems).
- For direct ignition burners with unlimited capacity in permanent operation and in accordance with EN 746-2:1998 and EN 746-2:2010.
- Single microcontroller technology for customization of the work cycle, multiple relighting attempts, and precise and repeatable setting times;
